Test dialog to set
motion detector sensitivity
The motion detector requires you to find a
reasonable sensitivity to control the notification trigger. If you have
a small area, you may set sensitivity lower. If you have a large area,
you may need to set it high, although you may expect to receive some
“false” alarm caused by wind or animals.
Monitor for intrusion
You may use a regular
web camera to monitor for intrusion.
Notification via
e-mails
To have a notification
send to you after a motion detected, you need to have valid email
addresses and permanent connection of Internet. MyOneLink supports three
email addresses. Each notification message has two picture attached, so
that when you get the picture, you know who was in your home. If your
cell phone support email receiving and picture displaying, you should be
able to see the pictures from your cell phone
Notification phone calls
For people don’t have
email access during the day, they may use this calls. After a motion is
detected, three calls may be generated using the presaved voice
messages. You can change the default recordings
Daily scheduled
monitoring
If you have regular daily schedule to
enter/leaving your monitoring area, you may use this scheduled
monitoring. Espeically, it is good for people who work 5 day x 8 hours
schedule.
Special time schedule for monitoring
When you have a
vacation or holiday, you may use this schedule to control your home or a
special area. You can set day and hour to start and day and hour to turn
off. |
